Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual page 220

Configuring Secure Access Devices Guide
Related
Documentation
202
Table 52: Authentication Realm Policies Configuration Details (continued)
Option Function
Cache Cleaner Specifies the cache cleaner
option restrictions.
NOTE: The Cache Cleaner tab
is displayed only when you
configure user realm policies.
Authentication Policies > Limits tab
Limit number Limits the number of
of concurrent concurrent users on the realm.
users
Guaranteed Specifies any number of users
minimum between zero (0) and the
maximum number of
concurrent users defined for
the realm, or you can set the
number up to the maximum
allowed by your license if there
is no realm maximum.
Maximum Specifies any number of
concurrent users from the
minimum number you specified
up to the maximum number of
licensed users. If you enter a
zero (0) into the Maximum box,
no users are allowed to login to
the realm.
Configuring Secure Access Role Mapping Rules (NSM Procedure) on page 203
Configuring Secure Access Sign-In Policies (NSM Procedure) on page 207
Your Action
Select one of the following option:
Disable Cache Cleaner— Does not require
Cache Cleaner to be installed or running for
the user to meet the access requirement.
Just load Cache Cleaner (Loads after IVE
maps the user to a realm)—Does not require
Cache Cleaner to be running for the user to
meet the access requirement but ensures that
it is available for future use. If you choose this
option for a realm's authentication policy,
then the Secure Access device downloads
Cache Cleaner to the client machine after the
user is authenticated and before the user is
mapped to any roles on the system.
Load and enforce Cache Cleaner (Loads
before IVE maps the user to a
realm)—Requires the Secure Access device
to download and run Cache Cleaner for the
user to meet the access requirement. If you
choose this option for a realm's authentication
policy, then the Secure Access device
downloads Cache Cleaner to the client
machine before the user may access the
Secure Access device sign-in page.
Select Authentication Policies > Limits >
Limit number of concurrent users to enable
this feature.
Enter a number.
Enter a number.
Copyright © 2010, Juniper Networks, Inc.