Configuring The Authentication Server (Nsm Procedure); Configuring The User Record Synchronization Server (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Configuring the Authentication Server (NSM Procedure)

Related
Documentation

Configuring the User Record Synchronization Server (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
To set up the authentication server, you must define its logical name:
To set up the authentication server:
In the NSM navigation tree, select Device Manager > Devices. Click the Device Tree
1.
tab, and then double-click the Secure Access device for which you want to configure
an authentication server.
Click the Configuration tab, and select Authentication > Auth Servers.
2.
Click the name of the authentication server you want to assign an LAS name.
3.
By assigning the authentication server a logical authentication server (LAS) name, all
users that authenticate using the authentication server are associated with this LAS.
In this instance, we are referring to the client nodes, not the user record synchronization
server nodes.
Select the User Record Synchronization check box.
4.
Enter a logical name to identify this server in the Logical Auth Server Name box.
5.
This allows you to share user record data across authentication servers on different
Secure Access gateways. By assigning an LAS name to an authentication server, you
are implicitly assigning it to all users that authenticate with that authentication server.
The combination of the user login name and its LAS name uniquely identifies the user
record of the user across all user record synchronization servers.
Click OK to save the changes.
6.
Enabling User Record Synchronization (NSM Procedure) on page 278
Configuring the User Record Synchronization Server (NSM Procedure) on page 279
To set up the user record synchronization server you must define its peer nodes (optional)
and the clients that can access this server.
To configure user record synchronization server:
In the NSM navigation tree, select Device Manager > Devices. Click the Device Tree
1.
tab, and then double-click the Secure Access device for which you want to configure
a user record synchronization server.
Click the Configuration tab, and select System > Configuration > User Record
2.
Synchronization > This Server.
Under Peer Servers tab, click New.
3.
Enter the peer server node name in the Server Node Name.
4.
Enter the peer IP address in the Internal Address box.
5.
Chapter 19: Synchronizing User Records
279