Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
CLI: Assigning Ports to VLAN3
(Netgear Switch) (Config)#interface range 1/0/2-1/0/4
(Netgear Switch) (conf-if-range-1/0/2-1/0/4)#vlan participation include 3
(Netgear Switch) (conf-if-range-1/0/2-1/0/4)#exit
(Netgear Switch) (Config)#interface 1/0/4
(Netgear Switch) (Interface 1/0/4)#vlan acceptframe all
(Netgear Switch) (Interface 1/0/4)#exit
(Netgear Switch) (Config)#exit
Web Interface: Assigning Ports to VLAN3
To use the Web interface to configure the managed switch, proceed as follows:
1.
Assign ports to VLAN 3.
a.
From the main menu, select Switching > VLAN >Advanced > VLAN Membership. A screen
similar to the following displays.
Figure 4-6
b. Select 3 from the VLAN ID pull-down menu
c.
Click the Unit 1. The Ports display.
d. Click the gray box under port 2,3 and 4 until T displays. The T specifies that the egress packet is
tagged for the port.
e.
Click Apply
2.
Specify that untagged frames will be accepted on port 1/0/4.
4-6
v1.0, November 2008
Virtual LANs
Advertisement
Table of Contents
