Configure The Switch With An External Multicast Router; Cli: Configuring The Switch With An External Multicast Router; Web Interface: Configuring The Switch With An External Multicast Router - NETGEAR FSM726E-100NAS Administration Manual

Configure the Switch with an External Multicast Router

The example is shown as CLI commands and as a Web interface procedure.

CLI: Configuring the Switch with an External Multicast Router

This example configures the interface as the one the multicast router is attached to. All IGMP packets
snooped by the switch will be forwarded to the multicast router reachable from this interface.
(Netgear Switch)(Interface 1/0/3)# ip igmp mrouter interface

Web Interface: Configuring the Switch with an External Multicast Router

To use the Web interface to configure the managed switch, proceed as follows:
1. From the main menu, select Switching > Multicast > Multicast Router Configuration. A screen similar
to the following displays.
Figure 15-4
IGMP Snooping and Querier
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
15-5