NETGEAR FSM726E-100NAS Administration Manual page 161

4. Enable IP Routing:
a. From the main menu, select Routing > IP > Basic > IP Configuration. A screen similar to the
following displays.
Figure 12-11
b. Under IP Configuration, make the following selections:
• Next to Routing Mode, select the Enable radio button.
• Next to IP Forwarding Mode, select the Enable radio button.
c. Click Apply to enable IP Routing.
5. Add a static route with IP address 192.268.40.0/24:
a. From the main menu, select Routing > Routing Table > Basic > Route Configuration. A screen
similar to the following displays.
Figure 12-12
b. Under Configure Routes, make the following selection and enter the following information:
• Select Static from the Route Type pull-down menu.
• In the Network Address field, enter 192.168.40.0.
• In the Subnet Mask field, enter 255.255.255.0.
Access Control Lists (ACLs)
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
12-15