Web Interface: Traceroute - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Tracing route over a maximum of 20 hops
1 10.254.24.1
2 10.254.253.1
3 63.237.23.33
4 63.144.4.1
5 63.144.1.141
6 205.171.21.89
7 205.171.8.154
8 205.171.8.222
9 205.171.251.34
10 209.244.219.181
11 209.244.11.9
12 4.68.121.146
13 4.79.228.2
14 216.115.96.185
15 216.109.120.203
16 216.109.118.74

Web Interface: Traceroute

To use the Web interface to configure the managed switch, proceed as follows:
1. Configure the Traceroute.
a. From the main menu, select Maintenance > Troubleshooting > Traceroute. A screen similar to the
following displays.
Figure 18-1
Use this screen to tell the switch to discover the routes that packets actually take when
traveling to their destination through the network on a hop-by-hop basis. Once you click the
18-2
40 ms 9 ms
30 ms 49 ms
29 ms 10 ms
39 ms 63 ms
70 ms 50 ms
39 ms 70 ms
70 ms 50 ms
70 ms 50 ms
60 ms 90 ms
60 ms 70 ms
60 ms 60 ms
50 ms 70 ms
60 ms 60 ms
110 ms 59 ms
70 ms 66 ms
78 ms 121 ms
v1.0, November 2008
10 ms
21 ms
10 ms
67 ms
50 ms
50 ms
70 ms
80 ms
50 ms
70 ms
50 ms
60 ms
60 ms
70 ms
95 ms
69 ms
Tools