Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Adding a Static Route
If your network switch has multiple routing interface that would allow different forwarding path to be taken
for reaching the same destination, it may make sense to create static route to force the packet to take certain
route (port) instead of the default route. The following procedure shows how to add static route to the switch
routing table.
CLI Command Procedure:
The following commands assume the switch has already defined a routing interface with network address of
10.10.10.0, and configured that all packets destined for network 10.10.100.0 take the path of routing port.
(FSM7328S) #show ip route
Total Number of Routes............................1
Network
Address
--------------- --------------- --------------- --------------- ---------------
10.10.10.0
255.255.255.0
To delete the static route, simply add "no" keyword in the front of the "ip route" command.
Web Interface Procedure
To configure a static route:
1.
Go to Routing > Routing Table > Route Configuration to display the Route Configuration page.
Figure 6-7
6-8
Subnet
Mask
Protocol
Local
v1.0, November 2008
Next Hop
Next Hop
Intf
IP Address
1/0/3
10.10.10.1
Port Routing
Advertisement
Table of Contents
