Enable Routing For The Switch; Cli: Enabling Routing For The Switch; Web Configuration: Enabling Routing For The Switch - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
The configuration commands used in the following example enable RIP on ports 1/0/2 and 1/0/3 as shown in
the network illustrated in
Port 1/0/2
192.150.2.2
Subnet 2
Figure 8-1

Enable Routing for the Switch

The example is shown as CLI commands and as a Web interface procedure.

CLI: Enabling Routing for the Switch

The following sequence enables routing for the switch:
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit

Web Configuration: Enabling Routing for the Switch

To use the Web interface to configure the managed switch, proceed as follows:
8-2
Figure 8-1
Layer 3 Switch
acting as a router
Subnet 3
v1.0, November 2008
Port 1/0/5
192.64.4.1
Port 1/0/3
192.130.3.1
Subnet 5
Routing Information Protocol