Enable RIP for the VLAN router ports. Authentication will default to none, and no default route entry will
be created.
(Netgear Switch) (Config)#interface vlan 10
(Netgear Switch) (Interface vlan 10)#ip rip
(Netgear Switch) (Interface vlan 10)#exit
(Netgear Switch) (Config)#interface vlan 20
(Netgear Switch) (Interface vlan 20)#ip rip
(Netgear Switch) (Interface vlan 20)#exit
(Netgear Switch) (Config)#exit
Web Interface: VLAN Routing RIP Configuration
To use the Web interface to configure RIP on the switch, proceed as follows:
1.
Configure a VLAN and include ports 1/0/2 in the VLAN:
a.
From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar to the
following displays.
Figure 8-9
b. Enter the following information in the VLAN Routing Wizard:
•
In the Vlan ID field, enter 10.
•
In the IP Address field, enter 192.150.3.1.
•
In the Network Mask field, enter 255.255.255.0.
c.
Click Unit 1. The ports display:
Click the gray box under port 2 once until T displays.
The T specifies that the egress packet is tagged for the port.
d.
Click Apply to save the VLAN that includes ports 2.
2.
Configure a VLAN and include ports 1/0/3 in the VLAN:
Routing Information Protocol
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
8-11