NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
•
In the VLAN Name field, enter VLAN3
•
Select Static from the VLAN Type pull-down menu.
c.
Click Add.
Assign Ports to VLAN2
This sequence shows how to assign ports to VLAN2, specify that frames will always be transmitted tagged
from all member ports, and that untagged frames will be rejected on receipt.
CLI: Assigning Ports to VLAN2
(Netgear Switch) #config
(Netgear Switch) (Config)#interface range 1/0/1-1/0/2
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan participation include 2
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan acceptframe vlanonly
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#vlan pvid 2
(Netgear Switch) (conf-if-range-1/0/1-1/0/2)#exit
(Netgear Switch) (Config)#vlan port tagging all 2
(Netgear Switch) (Config)#
Web Interface: Assigning Ports to VLAN2
To use the Web interface to configure the managed switch, proceed as follows:
1.
Assign ports to VLAN 2.
a.
From the main menu, select Switching > VLAN >Advanced > VLAN Membership. A screen
similar to the following displays.
Figure 4-4
b. Select 2 from the VLAN ID pull-down menu
4-4
v1.0, November 2008
Virtual LANs