Web Interface: Configuring A Protected Port To Isolate Ports On The Switch - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Step 4: Enable IProuting and configure a default route.
(Netgear Switch)(config)#ip routing
(Netgear Switch)(config)#ip route 0.0.0.0 0.0.0.0 10.100.5.252
Step 5: Enable a protected port on 1/0/23 and 1/0/24.
(Netgear Switch) (Config)#interface 1/0/23
(Netgear Switch) (Interface 1/0/23)#switchport protected
(Netgear Switch) (Interface 1/0/23)#exit
(Netgear Switch) (Config)#interface 1/0/24
(Netgear Switch) (Interface 1/0/24)#switchport protected
(Netgear Switch) (Interface 1/0/24)#exit

Web Interface: Configuring a Protected Port to Isolate Ports on the Switch

To use the Web Interface to configure a protected port in order to isolate ports, proceed as follows:
1. Create a DHCP pool:
Note: This example assumes that the DHCP service is enabled. For information about
how to enable the DHCP service, see the Web interface procedure in
"Configure a DHCP Server in Dynamic Mode" in Chapter 23
16-8
v1.0, November 2008
Security Management