Table of Contents
Advertisement
c.
Click the Unit 1. The Ports display.
d. Click the gray box under port 1 and 2 until T displays. The T specifies that the egress packet is
tagged for the port.
e.
Click Apply
2.
Specify that only tagged frames will be accepted on port 1/0/1 and 1/0/2.
a.
From the main menu, select Switching > VLAN> Advanced > Port PVID Configuration. A screen
similar to the following displays.
Figure 4-5
b. Under PVID Configuration, scroll down to interface 1/0/1 and select the checkbox for 1/0/1. Then
scroll down to the interface 1/0/2 and select the checkbox for 1/0/2.
c.
Enter the following information in the PVID Configuration.
•
select VLAN Only from the Acceptable Frame Type polyhedron menu.
•
Enter 2 in the PVID(1 to 4093) field.
d. Click Apply to save the settings.
Assign Ports to VLAN3
This example shows how to assign the ports that will belong to VLAN 3, and to specify that untagged
frames will be accepted on port 1/0/4. Note that port 1/0/2 belongs to both VLANs and that port 1/0/1 can
never belong to VLAN 3.
Virtual LANs
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
4-5
Advertisement
Table of Contents
