Table of Contents
Advertisement
Enable VRRP on the port.
(Netgear Switch) (Interface 1/0/2)#ip vrrp 20 mode
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#exit
Web Interface: Configuring VRRP on a Master Router
To use the Web interface to configure VRRP on a master router on the switch, proceed as follows:
1.
Enable IP routing on the switch:
a.
From the main menu, select Routing > IP > IP Configuration. A screen similar to the following
displays.
Figure 11-2
b. Next to the Routing Mode, select the Enable radio button.
c.
Click Apply to save the settings.
2.
Assign IP address 192.150.2.1 to the port 1/0/2:
a.
From the main menu, select Routing > IP > Advanced> IP Interface Configuration. A screen
similar to the following displays.
Figure 11-3
Virtual Router Redundancy Protocol
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
11-3
Advertisement
Table of Contents
