Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Show IGMP Querier Status
The example is shown as CLI commands and as a Web interface procedure.
CLI: Showing IGMP Querier Status
To see the IGMP querier status, use the following command.
(Netgear switch) #show ip igmpsnooping querier 1
Vlan ID........................................ 1
Admin Mode..................................... Active
Query IP Address............................... 10.10.10.1
Querier Interval............................... 60
Query Packets Sent Count....................... 242
The command shows that the IGMP admin mode is Active. The mode is controlled by the ip igmpsnooping
command. If the mode is inactive, no query packet is sent.
Web Interface: Showing IGMP Querier Status
1.
From the main menu, select Switching > Multicast >IGMP Snooping Configuration. A screen similar to
the following displays.
Figure 15-8
2.
Click Refresh.
15-10
v1.0, November 2008
IGMP Snooping and Querier
Advertisement
Table of Contents
