Set The Dynamic And Static Limit On The Port 1/0/1; Web Interface: Setting The Dynamic And Static Limit On The Port 1/0/1; Cli: Setting The Dynamic And Static Limit On The Port 1/0/1 - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
• Dynamically locked MAC addresses are eligible to be learned by another port
• Static MAC addresses are not eligible for aging
• Dynamically locked addresses can be converted to statically locked addresses

Set the Dynamic and Static Limit on the Port 1/0/1

The example is shown as CLI commands and as a Web interface procedure.

CLI: Setting the Dynamic and Static Limit on the Port 1/0/1

(Netgear Switch) (Config)#port-security
Enable port-security globally
(Netgear Switch) (Config)#interface 1/0/1
(Netgear Switch) (Interface 1/0/1)#port-security
Enable port-security on port 1/0/1
(Netgear Switch) (Interface 1/0/1)#port-security max-dynamic 10
Set the dynamic limit to 10
(Netgear Switch) (Interface 1/0/1)#port-security max-static 3
Set the static limit to 3
(Netgear Switch) (Interface 1/0/1)#ex
(Netgear Switch) (Config)#ex
(Netgear Switch) #show port-security 1/0/1
Admin
Intf Mode
------ -------
1/0/1 Disabled
Web Interface: Setting the Dynamic and Static Limit on the
Port 1/0/1
1. To use the Web interface to enable port-security globally, proceed as follows:
16-2
Dynamic Static
Limit
----------
10
v1.0, November 2008
Violation
Limit Trap Mode
---------
3 Disabled
----------
Security Management