Setting Up The Switch Ip Address - NETGEAR FSM726E-100NAS Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
again, just enter N .
Enter new password:********
Confirm new password:********
Password Changed!
The 'enable' password required for switch configuration via the command line
interface is currently not configured. Do you wish to change it (Y/N/Q)?
Enter new password:********
Confirm new password:********
Password Changed!

Setting Up the Switch IP Address

After the password for both Admin and Enable mode is changed, you will be prompted to setup the IP
address of the switch.
Assigning an IP address to your switch management
Current IP Address Configuration
--------------------------------
IP address: 0.0.0.0
Subnet mask: 0.0.0.0
Would you like to assign an IP address now (Y/N/Q)?
IP Address:
Ezconfig will display the current IP address and subnet mask. By default, the network management IP
address uses DHCP protocol to have a DHCP server assign its IP address automatically. However, you can
overwrite the DHCP client mode by assigning a fixed IP address here. Once a fixed IP address is assigned,
Ezconfig automatically disables DHCP client mode and assigns the static IP address to the management
VLAN.
If an IP address is already assigned, and you do not wish to change the IP address again, simply type N.
2-2
v1.0, November 2008
y
Using Ezconfig for Switch Setup
y