Table of Contents
Advertisement
The example is shown as CLI commands and as a Web interface procedure.
CLI: Specifying the Source (Mirrored) Ports and Destination (Probe)
(Netgear Switch)#config
(Netgear Switch)(Config)#monitor session 1 mode
Enable mirror
(Netgear Switch)(Config)#monitor session 1 source interface 1/0/2
Specify the source interface.
(Netgear Switch)(Config)#monitor session 1 destination interface 1/0/3
Specify the destination interface.
(Netgear Switch)(Config)#exit
(Netgear Switch)#show monitor session 1
Session ID
Admin Mode
-------------
1
Web Interface: Specifying the Source (Mirrored) Ports and Destination
(Probe)
To use the Web interface to show monitor session, proceed as follows:
1.
From the main menu, select Monitoring > Mirroring>Port Mirroring. A screen similar to the following
displays.
Figure 18-2
2.
Under Multiple Port Mirroring, scroll down to interface 1/0/2 and select the checkbox for
1/0/2. The value 1/0/2 now appears in the Interface field at the top.
3.
Enter the following information in the Status Table.
•
In the Destination Port field, enter 1/0/3.
•
Select Enable from the Session Mode pull-down menu.
Tools
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Probe Port
---------------
Enable
v1.0, November 2008
Mirrored Port
-------------
----------------
1/0/3
1/0/2
18-7
Advertisement
Table of Contents
