Command Mode - NETGEAR FSM726E-100NAS Administration Manual

Table 1-1. Quick Start Commands (continued)
Command
users passwd
<username>
copy system:running-
config nvram:startup-
config
logout
show network
network parms <ipaddr>
<netmask> [gateway]
Getting Started
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Mode
Global Allows the user to set passwords or change passwords
Config needed to login.
A prompt appears after the command is entered requesting
the users old password. In the absence of an old password
leave the area blank.
User password should not be more than eight characters in
length.
Privileged Saves passwords and all other changes to the device.
EXEC If you do not save the configuration, all changes are lost when
you power down or reset the networking device. In a stacking
environment, the running configuration is saved in all units of
the stack.
User EXEC Logs the user out of the networking device.
Privileged
EXEC
User EXEC Displays the following network configuration information:
• IP Address - IP Address of the interface (default: 0.0.0.0)
• Subnet Mask - IP Subnet Mask for the interface (default:
0.0.0.0)
• Default Gateway - The default Gateway for this interface
(default: 0.0.0.0)
• Burned in MAC Address - The Burned in MAC Address used
for in-band connectivity
• Locally Administered MAC Address - Can be configured to
allow a locally administered MAC address
• MAC Address Type - Specifies which MAC address should
be used for in-band connectivity
• Network Configurations Protocol Current - Indicates which
network protocol is being used (default: none)
• Management VLAN Id - Specifies VLAN id
• Web Mode - Indicates whether HTTP/Web is enabled.
• Java Mode - Indicates whether java mode is enabled.
Privileged Sets the IP address, subnet mask and gateway of the router.
EXEC The IP address and the gateway must be on the same subnet.
IP address range is from 0.0.0.0 to 255.255.255.255.
v1.0, November 2008
Description
1-7