NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Web Interface: Configuring a One-Way Access Using a TCP Flag in an ACL
To use the Web interface to isolate VLANs on a Layer 3 switch by using ACLs, proceed as follows:
1.
Create VLAN 24 with IP address 192.168.24.1:
a.
From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar to the
following displays.
Figure 12-28
b. Enter the following information in the VLAN Routing Wizard:
•
In the Vlan ID field, enter 24.
•
In the IP Address field, enter 192.168.24.1.
•
In the Network Mask field, enter 255.255.255.0.
c.
Click Unit 1. The ports display.
d. Click the gray box under port 24 twice until U displays. The U specifies that the egress packet is
untagged for the port.
e.
Click Apply to save VLAN 24.
2.
Create VLAN 48 with IP address 192.168.48.1:
12-28
v1.0, November 2008
Access Control Lists (ACLs)