•
Queue management type, Tail Drop vs. WRED
Only if per queue config is not supported
•
WRED Decay Exponent
•
Traffic Shaping for an entire interface
Show classofservice Trust
CLI: Showing classofservice trust
To use the CLI to show CoS trust mode, use these commands.
(Netgear Switch) #show classofservice trust?
<cr>
(Netgear Switch) #show classofservice trust
Class of Service Trust Mode: Dot1P
Web Interface: Showing classofservice Trust
To use the Web interface to show CoS trust mode, proceed as follows:
From the main menu, select QoS > Basic >CoS configuration. A screen similar to the following displays.
Figure 13-1
Set classofservice trust Mode
The example is shown as CLI commands and as a Web interface procedure.
Class of Service (CoS) Queuing
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Press Enter to execute the command.
v1.0, November 2008
13-3