Table of Contents
Advertisement
e.
Click Apply to save the settings.
2.
Add ports to the lag_20.
a.
From the main menu, select Switching > LAG >LAG Membership. A screen similar to the
following displays.
Figure 5-5
b. Under the LAG Membership Configuration , enter the following information.
Select the Lag 2 from the LAG ID pull-down menu.
c.
Click the Unit 1. The Ports display.
d. Click on the gray box under port 8 and 9. Two flags appear in the box.
e.
Click Apply to save the settings.
Enable Both LAGs
The example is shown as CLI commands and as a Web interface procedure.
CLI: Enabling Both LAGs
By default, the system enables link trap notification
(Console) #config
(Console) (Config)#port-channel adminmode all
(Console) (Config)#exit
At this point, the LAGs could be added to VLANs.
Link Aggregation
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
5-5
Advertisement
Table of Contents
