NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
b. Under IP Interface Configuration, scroll down to interface 1/0/2 and select the checkbox for that
interface. 1/0/2 now appears in the Interface field at the top.
c.
Enter the following information in the IP Interface Configuration:
•
In the IP Address field, enter 192.150.2.1.
•
In the Network Mask field, enter 255.255.0.0.
•
Select Enable from the Routing Mode pull-down menu.
d. Click Apply to save the settings.
3.
Enable VRRP on the 1/0/2:
a.
From the main menu, select Routing > VRRP > Advanced> VRRP Configuration. A screen similar
to the following displays.
Figure 11-4
b. Under Global Configuration, next to the Admin Mode, select Enable radio button.
c.
Enter the following information in the VRRP Configuration:
•
In the VRID(1 to 255) field, enter 20.
•
Select 1/0/2 from the Interface pull-down menu.
•
In the Primary IP Address, enter 192.150.2.1.
•
Select Active from the Mode pull-down menu.
d. Click Apply to save the settings.
Configure VRRP on a Backup Router
The example is shown as CLI commands and as a Web interface procedure.
11-4
v1.0, November 2008
Virtual Router Redundancy Protocol