CLI: Add a Default Route
(FSM7338S) (Config) #ip route default ?
<nexthopip> Enter the IP Address of the next router.
(FSM7328S) (Config)#ip route default 10.10.10.2
Note that IP subnet "10.10.10.0" should be configured via either Port Routing Configuration example either
or VLAN Routing Configuration in the next chapter. See
Web Interface: Add a Default Route
1.
Go to Routing > Routing Table > Route Configuration. The Route Configuration page displays.
Figure 6-6
1.
From the Route Type drop down menu, select DefaultRoute.
2.
Enter one of the routing interface's IP addresses in the Next Hop IP Address field.
•
The Network Address and Subnet Mask fields will not accept input as they are not needed.
•
The Preference field is optional. A value of 1 (highest) will be assigned by default if not specified.
3.
Click the Add button on the bottom of the page. This creates the Default Route entry into the route
table.
Port Routing
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
6-7