Set CoS Trust Mode of an Interface
CLI: Setting CoS Trust Mode of an Interface
(Netgear Switch) (Interface 1/0/3)#classofservice trust?
dot1p
ip-dscp
(Netgear Switch) (Interface 1/0/3)#classofservice trust dot1p?
<cr>
(Netgear Switch) (Interface 1/0/3)#classofservice trust dot1p
Note: The Traffic Class value range is <0-6> instead of <0-7> because queue 7 is reserved in a
stacking build for stack control, and is therefore not configurable by the user.
Web Interface: Setting CoS Trust Mode of an Interface
To use the Web interface to set CoS trust mode of an interface, set Cos Trust Mode to dot1p of the interface
1/0/3:
1.
From the main menu, select QoS > Advanced >CoS Configuration. A screen similar to the following
displays.
Figure 13-6
Class of Service (CoS) Queuing
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Sets the Class of Service Trust Mode of an Interface
to 802.1p.
Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
Press Enter to execute the command.
v1.0, November 2008
13-9