Configure Ports Using The Device View - NETGEAR S3600 Series User Manual

S3600 Series 8- or 16-Port 10G/Multi-Gigabit Ethernet Smart Switch with 2 SFP+ Ports
The file transfer begins. The page displays information about the progress of the
file transfer. The switch applies the configuration automatically.
14. Reboot the switch by doing the following:
a. Select Maintenance > Reset.
The Reset page displays.
b. Click the Reboot Now button.
An Alert pop-up window displays.
The switch reboots.
c. Click the OK button to close the window.
When the reboot is finished, the Device Admin Password page displays.
15. Log in again.
The Dashboard page displays. You can now configure the switch using all options
in the device UI.
Configure ports using the Device
View
The Device View in the device UI displays the ports on the switch. This graphic tool
provides an alternate way to navigate to port configuration and monitoring options.
To configure ports using the Device View:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network,
or connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser and enter the IP address of the switch in the address field of
your web browser.
If you do not know the IP address of the switch, see Access the switch on-network
and connected to the Internet on page 25 or Access the switch off-network and not
connected to the Internet on page 32.
The Device Admin Password page displays.
If you did not yet activate your warranty, the Register to activate your warranty page
displays. For more information, see Register the switch on page 35.
3. Enter one of the following passwords:
Get Started 46 User Manual