NETGEAR FSM726E-100NAS Administration Manual page 92

NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
a. From the main menu, select Routing > VLAN > VLAN Routing Wizard. A screen similar to the
following displays.
Figure 8-10
b. Enter the following information in the VLAN Routing Wizard:
• In the Vlan ID field, enter 20.
• In the IP Address field, enter 192.150.4.1.
• In the Network Mask field, enter 255.255.255.0.
c. Click Unit 1. The ports display.
• Click the gray box under port 3 once until T displays.
The T specifies that the egress packet is tagged for the port.
d. Click Apply to save the VLAN that includes ports 3.
3. Enable RIP on the switch ( this step can be skipped since the RIP is enabled by default).
a. From the main menu, select Routing > RIP > Basic>RIP Configuration. A screen similar to the
following displays.
Figure 8-11
b. Next to the RIP Admin Mode, select Enable radio button.
c. Click Apply to save the setting.
4. Enable RIP on the VLAN 10 and 20.
8-12
v1.0, November 2008
Routing Information Protocol