NETGEAR FSM726E-100NAS Administration Manual page 89

• RIPv2 defined in RFC 1723
– Route specification is extended to include subnet mask and gateway
– The routing table is sent to a multicast address, reducing network traffic
– An authentication method is used for security
The 7000 Series Managed Switch supports both versions of RIP. You may configure a given port to:
• Receive packets in either or both formats.
• Transmit packets formatted for RIPv1 or RIPv2 or send RIPv2 packets to the RIPv1 broadcast address.
• Prevent any RIP packets from being received
• Prevent any RIP packets from being transmitted.
This example adds support for RIPv2 to the configuration created in the base VLAN routing example. A
second router, using port routing rather than VLAN routing, has been added to the network.
Port 1/0/2 VLAN
Router Port 1/3/1
192.150.3.1
Layer 2
Switch
VLAN 10
Figure 8-8
Routing Information Protocol
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
Layer 3 Switch
Router port 1/0/5
192.150.4.1
Port 1/0/3 VLAN
Router Port 1/3/2
192.150.4.1
Layer 2
Switch
VLAN 20
v1.0, November 2008
Router
8-9