Table of Contents
Advertisement
1.
From the main menu, select Routing > Basic >IP Configuration. A screen similar to the following
displays.
Figure 8-2
2.
Next to the Routing Mode, select the Enable radio button.
3.
Click Apply to save the settings.
Enable Routing for Ports
The example is shown as CLI commands and as a Web interface procedure.
CLI: Enabling Routing for Ports
Enable routing and assigns IP addresses for ports 1/0/2 and 1/0/3.
(Netgear Switch) #config
(Netgear Switch) (Config)#interface 1/0/2
(Netgear Switch) (Interface 1/0/2)#routing
(Netgear Switch) (Interface 1/0/2)#ip address 192.150.2.1 255.255.255.0
(Netgear Switch) (Interface 1/0/2)#exit
(Netgear Switch) (Config)#interface 1/0/3
(Netgear Switch) (Interface 1/0/3)#routing
(Netgear Switch) (Interface 1/0/3)#ip address 192.150.3.1 255.255.255.0
(Netgear Switch) (Interface 1/0/3)#exit
(Netgear Switch) (Config)#exit
Web Interface: Enabling Routing for the Ports
To use the Web interface to configure the managed switch, proceed as follows:
1.
Assign IP address 192.150.2.1/24 to the interface 1/0/2.
Routing Information Protocol
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
v1.0, November 2008
8-3
Advertisement
Table of Contents
