NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
b. Under Interface Configuration, scroll down to interface 2/0/19 and select the checkbox for that
interface. 2/0/19 now appears in the Interface field at the top.
•
In the OSPF Area ID field, enter 0.0.0.1.
•
Select the Enable from the OSPF Admin Mode pull-down menu.
c.
Click the Apply button to save the settings.
7.
Configure area 0.0.0.1 as a stub area.
a.
From the main menu, select Routing > OSPF > Advanced > Stub Area Configuration. A screen
similar to the following displays.
Figure 9-23
b. Enter the following information in the Sub Area Configuration.
•
In the Area ID field, enter 0.0.0.1.
•
Select Disable from the Import Summary LSA's pull-down menu.
c.
Click Add to save the settings.
CLI: Configuring Area 1 as a Stub Area on A2
Enable routing on the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#router ospf
Set the router id to 2.2.2.2.
(Netgear Switch) (Config-router)#router-id 2.2.2.2
Configure the area 0.0.0.1 as a stub area.
(Netgear Switch) (Config-router)#area 0.0.0.1 stub
9-22
v1.0, November 2008
OSPF