Configuring For Web Access; Starting The Web Interface - NETGEAR GSM5212P Software Setup Manual

Configuring for Web Access

To enable Web access to the switch:
1. Configure the switch for in-band connectivity. (See
Connectivity on page 5.)
2. Enable Web mode:
a. At the CLI prompt, enter the show network command.
b. Set Web Mode to Enabled.

Starting the Web Interface

Follow these steps to start the switch Web interface:
1. Enter the IP address of the switch in the Web browser address field.
2. When the Login screen displays, click Login.
3. Enter the appropriate user name and password. The user name and associated password
are the same as those used for the terminal interface. Click the Login button.
4. A menu displays, with selections on the left.
5. Make a selection by clicking it.
Web Interface Layout
The Web interface is called the Prosafe Control Center (PCC). When you use the switch's IP
address to log in to the switch, the following screen displays:
7000 Series Managed Switch
Getting Started
16
Configuring the Switch for In-Band