Resetting Mbgp Connections; Clearing Mbgp Information; Mbgp Configuration Example - 3Com S7906E Configuration Manual

Resetting MBGP Connections

To do...
Reset specified MBGP
connections

Clearing MBGP Information

To do...
Clear dampened routing
information and release
suppressed routes
Clear MBGP route flap
statistics

MBGP Configuration Example

Network requirements
As shown in the following figure:
PIM-SM 1 is in AS 100 and PIM-SM 2 is in AS 200. OSPF is the IGP in the two ASs, and MBGP
runs between the two ASs to exchange multicast route information.
The multicast source belongs to PIM-SM 1, and the receiver belongs to PIM-SM 2.
It is required that the respective Loopback 0 of Switch A and Switch B be configured as the C-BSR
and C-RP of the respective PIM-SM domains.
Router A and Router B establishes an MSDP peer relationship through MBGP.
Use the command...
reset bgp ipv4 multicast { all |
as-number | ip-address | group
group-name | external | internal }
Use the command...
reset bgp ipv4 multicast
dampening [ ip-address [ mask
| mask-length ] ]
reset bgp ipv4 multicast
flap-info [ regexp
as-path-regexp | as-path-acl
as-path-acl-number |
ip-address [ mask |
mask-length ] ]
1-17
Remarks
Available in user view
Remarks
Available in user view
Available in user view