3Com S7906E Configuration Manual page 1139

[SwitchB] bgp 200
[SwitchB-bgp] router-id 2.2.2.2
[SwitchB-bgp] peer 192.168.1.1 as-number 100
[SwitchB-bgp] import-route ospf 1
[SwitchB-bgp] ipv4-family multicast
[SwitchB-bgp-af-mul] peer 192.168.1.1 enable
[SwitchB-bgp-af-mul] import-route ospf 1
[SwitchB-bgp-af-mul] quit
[SwitchB-bgp] quit
6) Configure MSDP peer
# Specify the MSDP peer on Switch A.
[SwitchA] msdp
[SwitchA-msdp] peer 192.168.1.2 connect-interface vlan-interface 101
[SwitchA-msdp] quit
# Specify the MSDP peer on Switch B.
[SwitchB] msdp
[SwitchB-msdp] peer 192.168.1.1 connect-interface vlan-interface 101
[SwitchB-msdp] quit
7) Verify the configuration
You can use the display bgp multicast peer command to display MBGP peers on a switch. For
example, display MBGP peers on Switch B.
[SwitchB] display bgp multicast peer
BGP local router ID : 2.2.2.2
Local AS number : 200
Total number of peers : 3
Peer V AS
192.168.1.1 4 100
You can use the display msdp brief command to display MSDP peers on a switch. For example,
display brief information about MSDP peers on Switch B.
[SwitchB] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured Up
1 1
Peer's Address State
192.168.1.1 Up
Peers in established state : 3
MsgRcvd MsgSent OutQ PrefRcv Up/Down
56 56
Listen Connect
0 0
Up/Down time
00:07:17
1-20
State
0 0 00:40:54 Established
Shutdown
0
AS SA Count Reset Count
100 1 0
Down
0