Configuring Directly Connected Map Access Points - 3Com 3CRWX120695A Reference Manual

274 C 6: C
HAPTER ONFIGURING
Configuring
Directly Connected
MAP Access Points
W P
IRELESS ARAMETERS
To apply a radio profile to radios
1 In the Create Radio Profile wizard, click Radio Selection. The Radio
Selection page appears.
If the Available Members column is empty, as shown in this example, no
MAP access points have been configured for the WX switch yet. To
configure MAP access points, see "Configuring Directly Connected MAP
Access Points" on page 274 and "Configuring Distributed MAP Access
Points" on page 284. After you configure the MAP access points, return
to this wizard page to apply the radio profile to radios.
2 Select the radios from the Available Members column.
3 Click Add to move the radios to the Current Members column.
4 Click Finish to save the changes and close the wizard.
MAP access points contain radios that provide networking between your
wired network and IEEE 802.11 wireless users. a MAP can connect to the
wired network through a direct 10/100 Ethernet connection to a WX or