3Com 3CRWX120695A Reference Manual page 220

220 C 5: C
HAPTER ONFIGURING
WX S A
YSTEM AND DMINISTRATIVE
Notice — Events that can cause system problems have occurred.
These are logged for diagnostic purposes.
Info — Informational messages only. No problems exist.
Debug — Output from debugging.
The default severity level is Error.
The debug level produces a lot of messages, many of which can appear
to be somewhat cryptic. Debug messages are used primarily by 3Com for
troubleshooting and are not intended for administrator use.
3 Configure logging to the console:
a To specify that logging messages be sent to the console, select
Enabled. Clear Enabled to disable the logging of messages to the
console.
b In the Severity Filter list, select the lowest level of severity of the event
or condition to be logged (see the list in step 2).
The default severity level is Error.
4 Configure logging to the current login session:
a To specify that logging messages be sent to the current login session,
select Enabled. Clear Enabled to disable the logging of messages
sent to the current login session.
b In the Severity Filter list, select the lowest level of severity of the event
or condition to be logged (see the list in step 2).
The default severity level is Info.
5 Configure trace logging:
a To enable trace logging, select Enabled. Clear Enabled to disable
trace logging.
b In the Severity Filter list, select the lowest level of severity of the event
or condition to be logged (see the list in step 2).
The default severity level is Debug.
c In the Maximum Size box, specify the maximum size for the trace log
(1 to 50 MB). The default is 1 MB.
P
ARAMETERS