3Com 3CRWX120695A Reference Manual page 263

Wired Equivalent Privacy (WEP) with 104-bit keys — 104-bit WEP uses
the RC4 encryption algorithm with a 104-bit key.
WEP with 40-bit keys — 40-bit WEP uses the RC4 encryption
algorithm with a 40-bit key.
You can configure MAP access points to support one or more of these
cipher suites. For all of these cipher suites, MSS dynamically generates
unique keys for each session. MSS periodically changes the keys to reduce
the likelihood that a network intruder can intercept enough frames to
decode a key.
WPA access points and clients verify the integrity of a wireless frame
received on the network by generating a keyed message integrity check
(MIC). The Michael MIC used with TKIP provides a holddown mechanism
to protect the network against tampering.
The MIC used by CCMP — CBC-MAC — is stronger than the one used by
Michael and does not require or provide countermeasures. WEP does not
use a MIC. Instead, WEP performs a cyclic redundancy check (CRC) on
the frame and generates an integrity check value (ICV).
To configure WPA authentication
1 To enable 802.1X authentication, select 802.1x Auth Enabled.
By default, this option is selected. To disable this option, clear the 802.1x
Auth Enabled checkbox.
2 Do one of the following:
To configure PSK authentication, go to step 3.
If you are not configuring PSK authentication, see "To configure WPA
encryption choices" on page 264.
3 In the Encryption page of the Create Radio Profile wizard, select PSK
Auth Enabled. By default, PSK authentication is not enabled.
4 In the Pre-shared Key box, do one of the following:
Type the preshared key — a 64-digit hexadecimal string (256 bits
long).
Type a passphrase.
Rather than type the preshared key, you can specify a passphrase that
is used to generate a preshared key.
Configuring a Service Profile 263