13 To change the default MAP model, select the model from the Default
MAP Choice list:
AP2750—Single-radio model.
MP-352—Dual-radio model.
MP-341—Single-radio model.
MP-252—Dual-radio model.
MP-241—Single-radio model.
MP-52—Dual-radio model.
MP-122—Dual-radio model.
MP-101—Single-radio model.
AP (Single Radio)—Third-party single-radio access point.
AP (Dual Radio)—Third-party dual-radio access point.
If this is a shared area (more than one radio technology), only dual-radio
models are listed. If the area is not shared, all models are listed.
14 To change the MAP connection type, select the type from the MAP
Connection Type list:
Direct — MAPs are directly attached to dedicated WX switch ports.
(Applies to WX1200 switches only.)
Distributed — MAPs can be indirectly attached through intermediate
Layer 2 or Layer 3 devices.
If the MAP access points are directly connected to the WX, ensure that
UTP Cat 5 cabling distances between the MAP and the WX in the wiring
closet do not exceed 100 meters (330 feet).
An indirectly attached MAP access point requires Power over Ethernet
(PoE) from a source other than a WX switch, such as a power injector.
15 To allow locked MAP access points to be deleted when Compute and
Place determines that they are no longer required, select Allow Deletion
of Locked MAPs.
A locked MAP is a MAP that is already associated with the coverage area.
For example, if you computed and placed MAPs in this coverage area on
a previous occasion and you are now optimizing the plan, the MAPs are
still associated with the coverage area.
16 To change the amount of power to reserve when calculating optimal
power, type or select the number of dBm in the Reserved Tx Power
Defining Wireless Coverage Areas
147