372
C
8: M
HAPTER
ANAGING
WX S
I
YSTEM
MAGES AND
1 In the main 3WXM window, select Changes > Upload. The Upload
Wireless Switch wizard appears.
2 In the IP Address box, type the IP address for the WX switch.
3 In the Enable Password box, type the enable password for the WX switch.
This password must match the enable password that was defined using
the CLI command set enablepass. For more information, see the
Wireless LAN Switch and Controller Configuration Guide.
4 Click Next. The uploading progress is shown.
5 Click Next. The verification progress is shown.
When you upload a WX, its configuration is verified if the Verify before
deployment and upload option is selected in the Preferences dialog
box. (By default, this option is selected.) During verification, 3WXM
checks the entire configuration for inconsistencies and dependencies. For
more information, see "Verifying Configuration Information" on
page 373.
6 Click Finish. If the upload is successful, you see the WX in the Mobility
Domain.
If the upload is not successful, check the following:
Make sure that the WX is running by using the ping command.
C
ONFIGURATIONS