200
C
5: C
HAPTER
ONFIGURING
WX S
A
YSTEM AND
DMINISTRATIVE
4 To enable spanning tree packet processing (Tx/Rx) on that port, make sure
Enabled is selected. This is the default.
To disable this feature, clear Enabled. If you disable spanning tree packet
processing on the port, the following might happen:
If STP is enabled on the VLAN, spanning tree packets are dropped at
the port.
If STP is disabled on the VLAN, spanning tree packets are forwarded
transparently through the VLAN to and from that port.
5 In the Port Priority box, specify a priority value (0 to 255). The default is
128.
6 In the Path Cost box, specify a value (0 to 65,535) for the cost. The
default depends on the port speed:
10 Mbps — The default is 100.
100 Mbps — The default is 19.
1000 Mbps — The default is 4.
Specify 0 to use the default cost for the port based on link speed.
7 To enable port fast convergence, select the PortFast checkbox.
8 Click Finish. The Create VLAN wizard is now active.
9 Repeat step 2 through step 8 for each port you want to modify.
P
ARAMETERS