234
C
5: C
HAPTER
ONFIGURING
WX S
A
YSTEM AND
7 To specify the speed of a 10/100 Ethernet port, select one of the
following:
Auto — Sets the port to automatically detect the traffic speed and set
the speed accordingly. This is the default value.
10 — Sets the speed to 10 Mbps.
100 — Sets the speed to 100 Mbps.
The port speed for gigabit Ethernet ports is predefined as 1000 Mbps and
cannot be configured.
8 To specify the operating mode of a 10/100 Ethernet port, select Half for
half-duplex or Full for full-duplex mode.
WX1200 ports support full-duplex mode only.
9 To specify the physical interface preference for a WX4400 port, select one
of the following from the PHY Media Preference list box:
GBIC — The port uses the fiber link as the active link.
RJ45 — The port uses the RJ-45 link as the active link.
The PHY Media Preference list box is displayed only for WX4400 ports.
10 To enable SNMP link traps and 3WXM polling on the port, select SNMP
Link Traps/3WXM Monitoring Enabled.
By default, this option is disabled. If you enable it, SNMP link traps are
sent when the port state changes, and 3WXM also polls and monitors the
port's status. To generate the LinkDown and LinkUp SNMP traps, you
must enable this option.
You also must globally enable SNMP traps. See "Configuring Logging" on
page 218.
11 Click Finish.
12 Do one of the following:
Go to "Configuring Load Sharing".
Select another item in the WX Switch wizard, if you are using this
wizard.
Click Finish to close the wizard and save changes.
P
DMINISTRATIVE
ARAMETERS