116
C
4: P
HAPTER
LANNING THE
3C
M
S
OM
OBILITY
YSTEM
5 Read the message about verifying the drawing scale, then click OK.
("Adjusting the Scale of a Drawing" on page 120 describes how to adjust
the scale.)
The drawing is displayed in the View panel.
Figure 2 Floor Plan After Importing
6 Do one of the following:
Click Finish to save the changes and close the wizard.
Change floor properties. See "Modifying Floor Defaults" on page 108
or "Changing an Individual Floor's Properties" on page 127.
Edit floor contents. Go to "Cropping the Paper Space" to begin.