3 In IP Address, type the IP address of the syslog server.
4 In the Severity Filter list, select the lowest level of severity of the event or
condition to be logged (see the list in step 2 of "Setting Up System
Logging" on page 218). The default severity level is Error.
5 To map all the facilities to a standard local facility, select Facility
Mapping.
Some syslog servers require the facility to be set to a standard local facility
name.
6 In the Map to Local Facility List, select the local facility (Local 0 to Local 7)
that all the facilities are mapped to. The default value is Local 0.
7 To close the Create Syslog Server dialog box, click Finish. The syslog
server is added to the list of servers on the Syslog Server Setup page.
8 To add more syslog servers, repeat step 2 through step 7. You can add a
maximum of four syslog servers.
9 Do one of the following:
To configure tracing, go to "Configuring Tracing" on page 224.
To set timezone parameters, go to "Setting the Timezone" on
page 226.
Configuring WX Management Services
223