Adding New Maps That Are Already Installed To The Network Plan - 3Com 3CRWX120695A Reference Manual

Adding New MAPs
that Are Already
Installed to the
Network Plan
3 To relock the coverage area:
a Select the coverage area.
b Right-click, and select Lock.
Locking and Unlocking MAP Access Points
After you compute and place the necessary MAP access points for a
coverage area, you can move them to fine-tune the wireless coverage. If
you need a MAP to be located at a fixed location on the floor, you can
lock its current location when you recompute the necessary coverage. A
dual-radio MAP model that is part of two coverage areas and is not
locked can be placed in the shared coverage area.
To lock a MAP
1 Select the MAP you want to lock.
2 Right-click, and select Lock. You can no longer move the MAP.
If you installed a new MAP in the network and you want to add it to the
network plan, do the following:
1 Use the Network Verification tab to upload the MAP configuration into
3WXM. (See "Verifying Configuration Information" on page 373.)
2 In the Organizer panel, right-click on the floor and select Properties. The
Building wizard appears.
3 Click Plan RF Coverage at the top of the wizard. The Plan RF Coverage
page appears.
4 In the Coverage Areas section, right-click on the coverage area for which
the MAP is providing coverage, and select Edit Properties. The Modify
Coverage Area wizard appears.
5 Click Area Associations at the top of the wizard.
6 Click Choose Available next to the Access Point List group box, and
select the MAP.
7 Click Finish to save the changes and close the wizard.
8 Click on Objects to Place.
9 Click on the MAP icon, then click on the location where you installed the
MAP. The MAP icon moves from the Objects To Place tab to its location
on the floor.
Computing MAP Placement 161