3Com 3CRWX120695A Reference Manual page 154

154 C 4: P
HAPTER LANNING THE
3C M S
OM OBILITY YSTEM
3 To change the height where MAPs are mounted, specify the new
mounting height in the MAP Placement Height box.
4 To change the WX switch model, select the model from the Use WX Type
list:
WX1200 — Provides eight 10/100 Ethernet ports, the first six of
which support PoE.
WX4400 — Provides four dual-interface gigabit Ethernet ports. Each
port has a 1000BASE-TX copper interface and a Gigabit interface
converter (GBIC) slot for insertion of a 1000BASE-SX or 1000BASE-LX
fiber-optic interface.
5 To change the default MAP model, select the model from the Default
MAP Choice list:
AP2750—Single-radio model.
MP-352—Dual-radio model.
MP-341—Single-radio model.
MP-252—Dual-radio model.
MP-241—Single-radio model.
MP-52—Dual-radio model.
MP-122—Dual-radio model.
MP-101—Single-radio model.
AP (Single Radio)—Third-party single-radio access point.
AP (Dual Radio)—Third-party dual-radio access point.
6 To change the MAP connection type, select the type from the MAP
Connection Type list:
Direct — MAPs are directly attached to dedicated WX switch ports.
(Applies to WX1200 switches only.)
Distributed — MAPs can be indirectly attached through intermediate
Layer 2 or Layer 3 devices.
If the MAP access points are directly connected to the WX, ensure that
UTP Cat 5 cabling distances between the MAP and the WX in the wiring
closet do not exceed 100 meters (330 feet).
An indirectly attached MAP access point requires Power over Ethernet
(PoE) from a source other than a WX switch, such as a power injector.