To Configure A Directly Connected Map - 3Com 3CRWX120695A Reference Manual

To configure a
directly connected
MAP
indirectly through other Layer 2 or Layer 3 wired networking devices.
Configure a MAP port for each directly connected MAP.
Table 20 lists how many MAPs you can configure on a WX switch, and
how many MAPs a switch can boot. The numbers are for directly
connected and Distributed MAPs combined.
Maximum MAPs Supported Per Switch
Table 20
WX Switch Model
WX4400
WX1200
For a MAP that is indirectly connected to the WX through an
intermediate Layer 2 or Layer 3 network, configure a Distributed MAP
instead. (See "Configuring Distributed MAP Access Points" on page 284.)
You cannot configure any gigabit Ethernet port, or port 7 or 8 on a
WX1200 switch, as a MAP port. To manage a MAP access point on a
WX4400 switch, configure a Distributed MAP connection on the WX
switch. (See "Configuring Distributed MAP Access Points" on page 284.)
To configure a directly connected MAP, use the following procedure.
1 Access the WX Switch wizard for the WX switch. (See "Accessing the
Modify Switch Wizard" on page 185.)
2 Select Wireless at the top of the wizard, if not already selected.
3 Select MAP from the organizer list on the left side of the page.
Configuring Directly Connected MAP Access Points
Maximum
Configured
256
30
Maximum Booted
24, 48, 72, or 96,
depending on the
license.
12
275