Planet Networking & Communication FGSD-1008HPS User Manual page 186

8/16/24-port 10/100mbps 802.3at poe + 2-port gigabit tp/sfp combo managed poe+ switch
Table of Contents

Advertisement

Configuring IP Address
3.
At the ">" prompt, enter the following command and press <Enter> as shown in
> config ip address 192.168.1.100
> config ip submask 255.255.255.0
The previous command would apply the following settings for the Managed PoE+ Switch.
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
4.
Repeat step 1 to check if the IP address has changed.
If the IP is successfully configured, the Managed PoE+ Switch will apply the new IP address setting immediately. You can
access the Web interface of Managed PoE+ Switch through the new IP address.
If you are not familiar with console command or the related parameter, enter "help" anytime in
console to get the help description.
You can change these settings, if desired, after you log on. This management method is often preferred because you can
remain connected and monitor the system during system reboots. Also, certain error messages are sent to the serial port,
regardless of the interface through which the associated action was initiated. A Macintosh or PC attachment can use any
terminal-emulation program for connecting to the terminal serial port. A workstation attachment under UNIX can use an emulator
such as TIP.
Figure 5-3: Configuring IP Address Screen
186
User's Manual of FGSW-Series
Figure
5-3.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FGSD-1008HPS and is the answer not in the manual?

This manual is also suitable for:

Fgsw-1816hpsFgsw-2624hpsFgsw-2624hps4

Table of Contents