Enable Command; Exit Command; Reboot Command - Planet Networking & Communication FGSD-1008HPS User Manual

6.7 Enable Command

Command Lists:
enable
DHCP_arp_inspection
DHCP_mac_verification
DHCP_snooping
dhcprelay
gvrp
igmp_snooping
imp_table
lldp
loop-detect
mac_table
mirror
mld_snooping
neighbor
ntp
poe
snmp
storm_ctrl
stp
stp-loop-detect
syslog
vlan

6.8 Exit Command

Command List:
exit Exit this CLI session.

6.9 Reboot Command

Command List:
reboot Reboot the Managed PoE+ Switch.
enable command, key in '?' to show the list
Used to enable DHCP Dynamic ARP Inspection function.
Used to enable DHCP MAC verification function.
Used to enable DHCP Snooping function.
Used to enable dhcprelay function.
Used to enable gvrp function.
Used to enable IGMP snooping function.
Used to enable IMP-table function.
Used to enable LLDP function.
Used to enable loop detect protocol.
Used to enable MAC-table function.
Used to enable mirror in standard mode.
Used to enable MLD snooping.
Used to enable neighbor MACID function.
Used to enable network time protocol function.
Used to enable poe ports.
Used to enable SNMP protocol.
Used to enable storm control function.
Used to enable STP function.
Used to enable STP loop detect protocol.
Used to enable syslog function.
Used to enable VLAN function.
192
User's Manual of FGSW-Series