Reset; Data Stream - Paradyne COMSPHERE 3920PLUS Installation And Operation Manual

Reset

Reset causes the modem to stop operation and perform a complete program restart. The
modem begins the power-up test sequence that ends with the Top-Level menu displayed on
the LCD. Configuration options stored in an Active (Saved) configuration area are copied to
the Active (Operating) configuration area.
To access Reset from the Control branch, make the following selection:
Select Reset.
The message Reset appears momentarily before the modem performs the power-up diagnostic test
sequence.

Data Stream

Use Data Stream to enable or disable the modem's data transmitter function on a specific port or
on all ports.
The Data Stream function is not available in Async mode in Singleport mode.
To access Data Stream from the Control branch, make the following selections:
Press the
If the mux is enabled, press the
Port2, Port3, Port4, or All. For information on selecting All, refer to Selecting All Ports later in this
section.
To select a port, press the appropriate function key (F1 or F3).
This screen does not appear if in Singleport mode or the DTE Bridge configuration option is
enabled.
Now go to the next screen (Data Stream).
3920-A2-GN31-30
Control: >
Speaker Reset
F3
F1 F2
Control:
Data_Stream
F1 F2 F3
key until Data Stream appears. Select Data Stream (F1).
Select DS Port >
Port1 Port2
F1 F2 F3
key to scroll the available ports into view. You may see Port1,
November 1996
DCP Operation
3-37