Connecting A High-Resolution Display Device - Matrox 4Sight-II Installation And Hardware Reference

30 Chapter 2: Connecting peripherals to the unit

Connecting a high-resolution display device

To connect your high-resolution monitor(s):
1. Connect the first monitor to the top analog VGA connector (connector #1) on
the Matrox 4Sight-II unit. If your monitor has a DB-15 connector, use a standard
DB-15 to DB-15 cable. If your monitor has 5 BNC-type connectors, use a
standard DB-15 to 5-BNC cable. To connect your monitor with a DB-15 to
5-BNC, refer to steps 2 and 3. These cables are usually supplied with your monitor.
2. If your monitor has input impedance switches, set the switches for the red, green,
and blue inputs to 75 ohms, as shown in the illustration below.
3. Set the switches for the synchronization inputs according to your monitor's
manual. In most cases, these switches should be set to high impedance and external
sync mode.
4. If you have a second high-resolution monitor, connect it to the bottom analog
VGA connector (connector #2) on the Matrox 4Sight-II unit, following the same
procedure as outlined in the above steps.
R
B
75 75 75
( B N C ) ( B N C )
( B N C )
RED BLUE GREEN
HSYNC
G VSYNC
75
INT
EXT
( B N C ) ( B N C )
WHITE BLACK
or
GRAY