Matrox 4Sight-II Installation And Hardware Reference page 140

140 Appendix B: BIOS reference
10. Unplug the power-supply from the motherboard/chassis for at least thirty seconds.
Important
11. Turn on your unit. Because CMOS memory has been cleared, you might see the
12. Press F2 to enter Setup.
13. The Main menu will be displayed.
14. A Setup Confirmation dialog box will appear, allowing you to confirm that the
15. Set the time by highlighting the System Time menu item, and entering the
16. Set the date by highlighting the System Date menu item, and entering the
17. Move to the Exit menu using the Left and Right keys.
18. Select the Exit Saving Changes menu item to save the configuration changes, exit
19. A Setup Confirmation dialog box will appear, allowing you to confirm that the
This is done to properly adjust the remote thermal diode and ambient temperature
trip points.
following message displayed on your screen:
"0251 System CMOS checksum bad - Previous boot or Default configuration
used"
This occurs because the BIOS does not detect any settings stored in CMOS
memory. The BIOS will load the default configuration settings. It will then
prompt you to continue with the boot or enter the Setup program to set the time,
or modify any configuration settings.
Press F9 to load the default configuration settings from the Flash memory.
default configuration settings should be loaded.
Using the Space key or the Left and Right keys, select Yes, and press Enter to
continue.
appropriate values for the hour, minute and second fields.
appropriate values for the month, date, and year fields.
Setup, and boot your main operating system.
default configuration settings should be loaded.