Connecting Devices To The Internal Connector Of The Parallel Interface - Matrox 4Sight-II Installation And Hardware Reference

Connecting a floppy
drive to the parallel
port connector

Connecting devices to the internal connector of the parallel interface

Connecting devices to the internal connector
of the parallel interface
If you have purchased the motherboard-only version of Matrox 4Sight-II, you will
have to connect parallel devices to the internal connector of the parallel interface,
located on the motherboard.
Internal connector of
the parallel interface
To connect to the internal connector of the parallel interface, you will need a
custom cable, with a 26-pin, IDC, female connector.
Pinout information for the internal connector of the parallel interface can be found
in Technical reference. You can also refer to this appendix, for information on where
the custom cable connector can be obtained.
You can connect a floppy disk drive to the internal parallel port connector. To do
so, you will need to make a custom cable to connect the disk drive to your unit.
Please refer to Connecting a floppy disk drive to the parallel port connector, for details.
PC/104- Plus TM
expansion site
Front Panel
57
DIMM slot
Internal
ATA-44connectors